Смена технологии быстрой зарядки литий-ионных аккумуляторов -Оборудование для литий-ионных аккумуляторов
The microscopic process of charging
Lithium batteries are known as "rocking chair" batteries, in which charged ions move between positive and negative electrodes to transfer charges to power external circuits or charge from an external power source. In the specific charging process, the external voltage is applied to the two poles of the battery, and the lithium ions are deintercalated from the positive electrode material and enter the electrolyte. At the same time, excess electrons are generated to pass through the positive electrode current collector and move to the negative electrode through the external circuit; lithium ions are in the electrolyte. It moves from the positive electrode to the negative electrode, and passes through the separator to the negative electrode; the SEI film passing through the surface of the negative electrode is embedded in the graphite layered structure of the negative electrode and combines with electrons.(Lithium - Ion Battery Equipment)
The structure of the battery, whether electrochemical or physical, that affects the charge transfer throughout the ionic and electronic operation will have an impact on the fast charging performance.
Fast charging, requirements for each part of the battery
For batteries, if you want to improve power performance, you need to work hard in all aspects of the battery as a whole, including positive electrodes, negative electrodes, electrolytes, diaphragms, and structural design.
positive electrode
In fact, almost all kinds of cathode materials can be used to make fast-charging batteries. The main performances that need to be guaranteed include conductance (reduce internal resistance), diffusion (guarantee reaction kinetics), life (no need to explain), safety (no need for Explanation), appropriate processing performance (the specific surface area should not be too large to reduce side reactions and serve safety).
Of course, the problems to be solved for each specific material may be different, but our common cathode materials can meet these requirements through a series of optimizations, but different materials are also different:
A. Lithium iron phosphate may focus more on solving the problems of electrical conductivity and low temperature. Carbon coating, moderate nano-ization (note that it is moderate, definitely not the simple logic of finer is better), and the formation of ionic conductors on the surface of particles are the most typical strategies.
B. The electrical conductivity of the ternary material itself is relatively good, but its reactivity is too high, so the ternary material is rarely nano-sized (nano-chemical is not an antidote for the improvement of material performance, especially in the field of batteries. There are sometimes a lot of adverse effects), and more attention is paid to safety and inhibition of side reactions (with electrolyte), after all, one of the key points of the current ternary materials is safety, and the recent frequent battery safety accidents are also in this regard. put forward higher requirements.
C. Lithium manganate pays more attention to life. At present, there are many lithium manganate series fast-charging batteries on the market.
negative electrode
When a lithium-ion battery is charged, lithium migrates to the negative electrode. The high potential brought by the high current of fast charging will cause the negative electrode potential to be more negative. At this time, the pressure of the negative electrode to quickly accept lithium will increase, and the tendency to generate lithium dendrites will increase. Therefore, the negative electrode must not only meet the lithium diffusion requirements during fast charging Therefore, the main technical difficulty of fast charging cells is actually the insertion of lithium ions in the negative electrode.
A. At present, the dominant negative electrode material in the market is still graphite (accounting for about 90% of the market share). There is no other fundamental reason - cheap, and the comprehensive processing performance and energy density of graphite are relatively good, and the shortcomings are relatively few. . Of course, the graphite negative electrode also has problems. Its surface is sensitive to the electrolyte, and the intercalation reaction of lithium has a strong directionality. Therefore, it is mainly necessary to perform graphite surface treatment to improve its structural stability and promote the diffusion of lithium ions on the substrate. direction.